W415-1476 / C / 10.03.17
19
EN
!
WARNING
BURNING YOUR APPLIANCE WITH THE DOORS OPEN OR AJAR CREATES A FIRE HAZARD THAT
MAY RESULT IN A HOUSE AND OR CHIMNEY FIRE.
DO NOT STRIKE OR SLAM DOOR.
NEVER REMOVE THE DOOR WHEN THE APPLIANCE IS HOT.
5.2 HANDLE AND DOOR SERVICE AND INSTALLATION
E
SPRING
PINS
SPRING
PINS
LATCH BLOCK
HANDLE
RESSORT
POIGNÉE
BLOC DE LOQUET
ÉPINGLES
ÉPINGLES
RESSORT
A.
Remove the two screws securing the latch block to the door.
B.
Pull the handle towards the inside of the door and remove the latch block components, then remove
the latch block and handle. Replace any damaged or worn components.
C.
To reinstall the door handle take the latch block and door handle, align the top and bottom screw
holes to the door, as illustrated.
D.
Loosely tighten the top screw and install the two pins, as illustrated.
E.
Installing the spring, slip it into the bottom of the latch block and then install the screw. Apply a small
amount of high temperature grease to the spring, prior to installation. HINT: Compress the spring
using a flat head screw driver, this allows for easy installation of the bottom screw, as shown
below.
F.
To ensure a proper installation, the handle support should have the ability to remain in an upwards
position. Additionally, the handle support should engage smoothly with the firebox.