Napoleon PTH-103-3G, Инструкции по установке, эксплуатации и обслуживанию

Страница: 11 / 21

PRECAUTIONS

Periodically check the whole gas system for
leaks or immediately check if the smell of
gas is detected

Extinguish all open flames.

Never leak test while smoking.

If you cannot stop a leak, turn off the gas
supply and call the Customer Service
hotline, the dealer where you made the
purchase or your gas supplier.

The heater must be checked with a full
cylinder.

Do not use the heater until all connections
have been leak tested and do not leak.

Only those parts recommended by the
manufacturer should be used. Substitution
can void the warranty.
GAS REQUIRMENTS

Maximum inlet pressure to propane
regulator must not exceed 100 PSI.

A minimum supply pressure of 11.0 W.C. is
required for the purpose of input adjustment
for propane gas.

The pressure regulator and hose assembly
supplied with the appliance must be used.
Replacement pressure regulator and hose
must be specified by the appliance
manufacturer.

The installation must conform with local
codes or in the absence of local codes, with
National
Fuel Gas Code, ANSI
Z223.1-1996.

The heater comes equipped with a hose
assembly for hook-up to a standard

A dented, rusted or damaged propane tank
may be hazardous and should be checked by your
tank supplier. Never use a propane tank with a
damaged valve connection.

The propane tank must be constructed and
marked in accordance with the specifications for
LP gas cylinders of the US Department Of
Transportation (DOT)

The propane tank must be arranged to provide
for vapor withdrawal from the operating
cylinder

Never connect an unregulated propane tank
to the heater
LEAK TESTING

Gas connections on the heater are leak tested at
the factory prior to shipment a complete gas
tightness check must be performed at the
installation on site due to possible miss handing
in shipment or excessive pressure being applied
to the heater.
TO LEAK TEST

Make a soap solution of one part liquid
detergent and one part water. The solution can
be applied with a spray bottle brush or rag.
Soap bubbles will appear where a leak is present

Make certain the safety control valve is in the
‘OFF’ position

Turn the gas supply ‘ON’.

If a leak is present turn ‘OFF’ the gas supply,
tighten any leaking fitting, turn gas supply ‘ON’
gas tank. The propane tank is not included. and recheck.
GAS REQUIREMENTS & LEAK TESTING
NEVER CONNECT AN UNREGULATED GAS SUPPLY TO THE HEATER
Page 9
propane