Napoleon Madison GD80NT, Инструкция по установке и эксплуатации

Страница: 27 / 40

27
W415-0695 / 05.12.08
Your comes equipped with our “Night Light™”. The light has been pre-wired and is controlled from the remote control.
If in the event the lamp or lens needs to be replaced, follow the instructions below.
1. Unplug the remote receiver from the junction box located behind the inner access panel (see Figure 57) .
2 . Remove the four screws that secure the lens frame. This frame retains the glass lens. The lamp can now be accessed.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect
with a clean dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel
parts only, as lamp and lens are special “high temperature” products.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the
lens. “Light Leakage” from the upper area may
be observed. The holes in the lamp housing
are necessary for ventilation and must not be
covered.
NIGHT LIGHT™ REPLACEMENT
FIGURE 53
GASKET
LENSE
FRAME
COLOURED
SIDE U
P
SCREWS
LENSE
FRAME
FIREBOX TOP
FIGURE 52
BLOWER REPLACEMENT
The MADISON comes equipped with a heat circulating blower.
The blower is pre-wired and is controlled by the remote control
supplied with the unit. For control details, see operation.
Drywall dust will penetrate into the blower bearings, caus-
ing irreparable damage. Care must be taken to prevent
drywall dust from coming into contact with the blower or
its compartment. Any damage resulting from this condition
is not covered by the warranty policy.
1. Turn off the power to the fi replace.
2. Turn off the gas valve.
3. Remove the glass door, logs, rear log support, side brick
panels, rear baffl e, and rear panel.
4. The mounting plate can now be removed. Remove the six
screws that secure the plate to the fi rebox back. The blower is
secured to this plate.
5. Disconnect the wire connectors and ground before attempt-
ing to remove the blower from the plate.
6. When re-installing the replacement blower, it will be necessary
to replace the gasket (W290-0091) on the mounting plate.
FIGURE 55
FIGURE 56
FIGURE 54
The control area can be accessed either through the control door or through the inner access panel inside the fi rebox.
Follow the door removal instructions (PG 26) . Remove the right side brick panel. Remove the four screws from the inner
access panel (see Figure 57) .
NOTE: A new gasket will be required, when re-installing the access panel (see replacement parts).
INNER ACCESS PANEL