Napoleon DHCP-BK, Инструкция по установке и эксплуатации

Страница: 19 / 72

EN
W415-1789 / C / 01.29.19
19
mounting options
In this mounting option, the exterior housing assembly
is surface-mounted to the finished exterior wall
without the use of a wall flashing. S
urface-mounting
requires the framing of a minimum Ø 6” (152mm)
clearance hole in the exterior wall for the air damper
assembly (see illustrations).
note:
When surface-mounting DHC™ Plus , ensure to fix
the appliance to studs.
6.3 surface
Ø 6”
(152mm)
hole
Exterior
Interior
Appliance
Vent Terminal
(if applicable)
12”
(30.5cm)
Ø 6” (152mm)
Hole &
Installed
Collar Plate
Assembly or
Enclosure
Top of
Enclosure
Air Outlet
Opening
Exterior Housing
Assembly
Exterior
Interior
Interior
Exterior
Appliance
Vent Terminal
(if applicable)
No materials of any type permitted in this
area with the exception of an approved
appliance vent system or the DHC™
Plus system.
Air Damper
Assembly
6’ Rigid
Steel Venting
Appliance
(LVX38 Illustrated)
Installed 6” Collar
Plate Assembly
Exterior Housing
Assembly
Interior
Exterior
Due to a variety of potential finish materials, brackets
to mount
DHC™ Plus need to be fabricated on-site
from suitable materials and attached using self-
drilling fasteners at the dimples provided on the
side of the housing. Suitable flashing, drip edges,
and sealing must be completed in accordance with
good construction practices to weather-proof the
installation.
Care must be taken to fasten the DHC™ Plus
securely, and the weight of the system must not be
supported by the ducting or air damper assembly.
Minimum Ø 6”
(152mm)
Clearance Hole
Recommended DHC™ Plus collar plate
assembly installation zone (12” [30.5cm]).
Left Side Profile View
(Remote Exterior Installation illustrated. Some components may not apply to
your unique installation.)
Top Side View
(Remote Exterior Installation illustrated. Some components may not apply to your unique installation.)
Remote Exterior Installation
illustrated with inline and
decorative covers installed