NAPCO GEMINI C Series, Инструкция по программированию, Страница: 29 / 52

NAPCO Gemini C - Series Control Panel Programming Instructions -- Volume 2
NAPCO Security Group
Programming Instructions, Volume 2 Page 97
BURG AREA EVENT REPO RTING OPTIONS (ADDRESS 8040-8051)
BURG AREA EVENT REPORTING OPTIONS:
For example, to send (via Telco 1) an Exit Error event report for Area 4, access address 8040, then press 4 to select Area 4.

1. Select the desired event type, either Exit Error , Recent Closing or CP01 Test Signal .

2. Enter the corresponding Area number in each the address location, in Binary (Bit) Format. NOTE: See Direct Address
Programming Example on page 72.

3. Press
U
to save.
NOTE: Dark shaded data value box shows option not available for that Area. Area 1 is a Fire Area only.
ADDR
AREAS 1 → 8
EXIT ERROR A1 A2 A3 A4 A5 A6 A7 A8
1 2 3 4 5 6 7 8
EVENT REPORT TELCO 1 8040
RESTORE REPORT TELCO 1 8041
EVENT REPORT TELCO 3 8042
RESTORE REPORT TELCO 3 8043
Default = blank (•) from address 8040 - 8043
ADDR
AREAS 1 → 8
RECENT CLOSE A1 A2 A3 A4 A5 A6 A7 A8
1 2 3 4 5 6 7 8
EVENT REPORT TELCO 1 8044
RESTORE REPORT TELCO 1 8045
EVENT REPORT TELCO 3 8046
RESTORE REPORT TELCO 3 8047
Default = blank (•) from address 8044 - 8047
ADDR
AREAS 1 → 8
CP01 TEST SIGNAL A1 A2 A3 A4 A5 A6 A7 A8
1 2 3 4 5 6 7 8
EVENT REPORT TELCO 1 8048
RESTORE REPORT TELCO 1 8049
EVENT REPORT TELCO 3 8050
RESTORE REPORT TELCO 3 8051
Default = blank (•) from address 8048 - 8051