Make sure you glue
the spar while the
assembly is on a flat
surface. Make sure
your wing stays
straight.
Sand a 45 degree
bevelled edge on the
ailerons. Make sure
you are sanding the
correct aileron and
you are sanding the
bottom side of it.
Apply Hinge tape or
Scotch tape to the
aileron top side first.
Trim the ends then
attach it to the wing.
Complete this for both
sides.
Then flip over the
ailerons all the way on
its back as shown.
Apply hinge tape to
the bottom as shown.
Trim the ends and
seal the aileron hinge
over the bottom side
of the wing.
Trim the end before
folding over the tape
to finish sealing the
aileron hinge.
Locate the 4 elevator
parts. Glue the to
halves together and
glue in the carbon
fiber spar. Work on
the elevator control
surfaces next.
Find the flat spar
about 13 inches and
the elevator section.
Place the spar over
the top of the elevator
as shown. Use it as a
guide to cut away the
color graphic tape.
Don’t discard the
tape. Peel it away
carefully as you will
re-apply it later.
Repeat the process
for both sides.
Remember save the
tape for re-
application.
Measure the flat spar
to length of the eleva-
tor spanwise. Cut the
length to match the
elevator span. Use
cutting shears. Be
careful of slivers and
splinters from the
carbon fiber.
