Continue with one
more level of filling
the sides with scrap
depron. Try to make it
from one piece on
each side. Secure
with more Thin foam
safe CA.
Sand the elevator slot
wider to accept the
elevator without
breaking the depron if
needed.
Glue the top part
together as shown.
Pinch it together with
your fingers without
cracking the depron.
Be gentle yet firm.
Squeeze the bottom
part as shown and
apply glue to fill any
poor glue adhesion.
The front of the
fuselage shown here
while belly side up.
The upright front view
of the fuselage.
With a sponge type
sanding block smooth
down the corners to
make a rounded
fuselage bottom.
Sand it round for the
full length of the
fuselage bottom.
This will help your
fuselage be more
streamlined and resist
drag better.
Fill any remaining
cracks and gaps with
lightweight spackling.
Let it dry and sand
smooth with fine sand
paper.
Use the end of an
Exacto knife and cold
crush all trailing
edges and leading
edges top & bottom
for all flying surfaces.
Wings, elevator and
rudder.
After cold crushing
the edges use a fine
sponge sand paper
and round smooth all
flying surfaces leading
and trailing edges.
