You will need to
detach the ailerons
and elevator from
both wing halves and
both elevator halves.
Flip over the elevator
on the table with the
graphic side face
down. With a hobby
knife carefully cut
down the hinge line to
cut the graphic tape.
If done correctly it
should be a clean cut.
Repeat this for the
other elevator as well.
The same process
needs to be done for
the ailerons. Place
one wing half face
down. You will need to
make two cuts.
The first cut shown
here.
The second cut
shown here.
Repeat this process
again for the remain-
ing wing half.
Again if done correctly
and with a sharp
hobby knife you
should have a clean
cut as shown.
Find the following
parts and lay out on
your work table as
shown. This will
ensure you build a
right and a left side.
Glue the half fuselage
to the former as
shown. There will be
about 3mm edge at
the slot. This is the
way it should look.
Make sure it stays
straight with no warps
until glue sets. Stack
books on top to be
sure it stays true.
A closer view shows
the positioning as it
should be.
A closer view of the
positioning as it
should be in the aft
section of the fuse-
lage half.
Complete both the left
and right fuselage
halves as shown.
You will need to widen
the slot for the eleva-
tor. Cut off about 3mm
from the top side.
