Chapter 2. Preparation and Installation
HR8 Motor User Manual
2-12
2.2.5 Motor
Run-In
Run-in of the motor is important to reduce wear rate of the system
and to increase its lifetime.
The required run-in conditions are as follows:
•
velocity - 50 mm/sec.
•
Duty cycle - 50%.
•
Duration - 4 hours.
When the run–in is completed, carefully clean the ceramic strip with
a Q-Tip soaked with IPA,
without dismounting the motor
.
General remarks:
1. The procedure should be repeated if the motor is disconnected
and then reinstalled.
2.
Do not perform run-in in a vacuum environment
.
