NANAWALL WD65 OWNER’S MANUAL
12
Operation And Maintenance
Of NanaWall Products
OPERATION OF A NANAWALL FOLDING UNIT
For opening and closing the folding system, please
observe the special notes on the following pages in as far
as they relate to your folding system.
When operating the folding system similar to
any other door, please do not place your fingers
between the panels/pivot points. You may hurt
them!
Do not have anyone not properly trained on operation
and children operate the unit.
Do not force the system if not operating properly.
Please have it repaired as soon as possible by a qualified
technician.
Anchor panels when in the open position to prevent
uncontrolled movement, especially in windy conditions,
that might cause damage and injury.
It is highly recommended that if not used, the NanaWall
folding unit be kept closed as much as possible, in order
to provide best security and weather resistance. When
closed, please engage all locking mechanisms fully.
The correct sequence of opening and closing of panels is
dependent on the configuration ordered. Panels must be
opened and closed in the right order.
With a Swing Panel Attached to a Folding Pair
1.
Open the swing panel a full 180
°
and connect
to the
panel catch on the adjacent panel.
2.
Disengage the locking points on all the other panels.
3.
Slide folding panels, starting with the pair adjacent to
the swing panel.
For closing, proceed in reverse order.
Without a Swing Panel
1.
Disengage locking points on primary opening panel
pair and fold it slightly.
2. Do the same with any adjacent panel pair.
3. Slide folding panels completely to the side.
For closing, proceed in reverse order.
With Unhinged Paired Panels and No Swing Panel
1.
Disengage locking points on primary opening panel
pair and fold it slightly.
2. Do the same with any adjacent panel pair (s).
3. Slide folding panels into desired stacking position.
For closing
,
proceed in reverse order.
1
1
2
2
3
3
2
1
2
3
1
1
2
2
3
3
2
1
2
3
1
1
2
2
3
3
2
1
2
3
