![background image](http://html2.mh-extra.com/html/namco/quick-and-crash/quick-and-crash_operators-manual_3181241083.webp)
Page 83
7-22
Replacing the Flat Target Sensor PC Board
Note: PC Boards are susceptible to damage from static electricity. Anti static
precautions should be taken when removing, handling and refitting the PC
Board.
1.
Remove the Flat Target Assembly.
(See Section 7-18 page 77).
2.
Disconnect connectors (J301) and (J302).
3.
Using needle nosed pliers, squeeze the locking tabs of the locking supports, one
at a time, to release the PC Board. Remove the Sensor PC Board.
4.
Replace the board by gently pushing the board on to the locking supports.
Note: When replacing the Sensor Pc Board, ensure that connector (J301) is located at
the front.
Locking Supports
Connector
(J302)
Flat Target
Sensor PC Board
Front
Connector
(J301)
Tab
Needle Nosed
Pliers
Stopper
Locking Support
PC Board
Содержание Quick & Crash
