NAMCO AquaJet, Руководство оператора

Страница: 32 / 57

Page 35
8-2-3 Replacing Solenoid Valve A
WARNING • Make sure that the power is turned OFF before
commencing any work.
1) Remove the tank. (Refer to section 8-2-2 ‘Removing the Tank’
2) Disconnect the connector.
3) Push the blue release of the elbow union in, and while holding it in,
pull out the air tube. (There will be a loud noise as the air pressure is
released.)
4) Remove the two pozi head screws (M4x35) and remove the solenoid
valve A.
5) Remove the elbow union, half union and silencer from the removed
solenoid valve, and install them on to the new solenoid valve.
6) Re-assemble in reverse order. (The air tube is just a push fit.)
NOTE:
•
Take care that no dirt or other matter gets in to the air tube while
it is disconnected.
• After refitting the air tube, give it a gentle pull to ensure that it is
connected properly and will not come loose.