NAMCO AquaJet, Руководство оператора

Страница: 13 / 57

Page PB
5-2 Fitting the Header Assembly
1. Place the Header Assembly on top of the monitor.
2. Lift the right end of the Header Assembly (as viewed from the front), and
connect the connector to the top of the monitor. (Ensure that a second
person prevents the Header Assembly from falling.)
3. Slide the Header Assembly towards the back of the monitor until it is fully
engaged in the locating bracket, taking care not to trap any wires.
4. Fasten the Header Assembly with the 3off M6x30 Hex head screws, flat
and spring washers.
WARNING • The Header Assembly has a forward centre of gravity, so it
is important that at least two people are used to fit or
remove the Header Assembly.
WARNING • The fitting position of the Header Assembly is very high,
and it is important that a means of reaching the height
safely, without stretching, is available. (e.g. steps, step
stools etc.)