Nakayama 015604, Руководство пользователя

Страница: 27 / 34

- 9 -
•
ADJUSTING THE THROTTLE CABLE
1. After releasing the throttle lever, pull the throttle
wire. The normal play is 1 or 2mm when
measured at the carburetor side end.
2. If the play is too much or too little, take off the air
cleaner cover, loosen the lock nut and adjust the
play.(F5)
(1) Adjust nut
(2) Lock nut
•
INSTALLING THE METAL BLADE (F6)
1. Set the inner holder to the gear shaft and turn it so that the hole is aligned with the
hole in the gear shaft, put the hex key in this hole to fixate for assembling the nut
2. Put the blade on the inner holder with the face with letters to the gear case, and
match the hole of the blade to the projection of the
inner holder correctly.
3. Set the outer holder to the gear shaft with the
hollowed face to the blade.
4. Put the attached top metal cover on the outer
holder and secure it with the nut.
5. Remove hex key.
(1) Wrench
(2) Nut
(3) Top metal cover
(4) Outer holder
(5) Blade
(6) Inner holder
(7) Gear shaft
(8) Hex key
(9) Gear case
•
INSTALLING THE NYLON CUTTER (F7)
1. Set correctly the inner holder to the gear shaft only.
（
see F6
）
2. Screw the attached bold (M10 Left) into the gear shaft
and secure it with the spanner.
3. Screw the nylon cutter into the bolt by fixing the inner
holder with the L-shaped bar and tighten it manually.
Keep bolts and washers to install the blade
carefully so as not to lose them
(1) Gear Case (3) Nylon cutter
(2) Bolt (4) Nylon cord
NOTE