Nakayama 015604, Руководство пользователя

Страница: 25 / 34

- 7 -
•
MAINTENANCE SAFETY PRECAUTION
1. Perform maintenance and checks described in this manual at regular intervals. If
any parts must be replaced or any maintenance or repair work not described in this
manual must be performed, please contact a representative from the store or
nearest authorized servicing dealer for assistance.
2. Under no circumstances should you ever take apart the brush cutter or alter it in
any way. Doing so might result in the brush cutter becoming damaged during
operation or becoming unable to operate properly.
3. Always be sure to turn off the engine before performing any maintenance or
checking procedures.
4. When sharpening, removing, or reattaching the blade, use proper tools and
equipment to prevent injury.
5. When replacing blade or any other parts or when replacing the oil or any lubricants,
always be sure to use only products or products which have been certified for use
with the brush cutter.
5. SET UP
•
HANDLE BAR SUPPORT SHAFT(F1)
1. Insert support shaft (A) in to bottom support
bracket (B).
2. Ensure the bottom of shaft and bracket is flush.
3. Tighten the two (2) 4mm Allen head screws (C)
with tools supplied with unit (D).
•
HANDLE BAR ASSEMBLY (F2)
1. Attach the handle bar assembly from right side of unit (refer page2 for reference).
2. Insert the two bolts (1) in through the shaft and handle bar.
3. Insert two washers (2).
4. Tighten the two handlebar knobs (3) to secure the handle in the correct operating
position.
Be careful not to crimp or pinch the engine switch wires and throttle cable.
NOTE