30
Preparation before use
3 – 4
Replacing the blade
ڦ
The blade is attached to the handpiece. Make sure the blade is securely attached before use.
1
Remove the cap by pulling it straight off.
2
Loosen the set screw at the end of the handpiece
with the supplied hexagon wrench, and remove the
old blade.
②
①
3
Insert the blade all the way into the Horn. The
correct orientation is having the set screw clamping
onto the Angled Flange Marks on the blade.
4
Tighten the set screws with a hexagon wrench.
When installing a new blade, tighten it in the center
so that both ends of the blade do not touch the horn.
The standard tightening torque is 1.5 N
・
m.
5
If less than 3.0W when the maximum output power is
displayed, the blade has been installed correctly. (See "6 -
4 Setting the Watt display and amplitude display.") 3.0W or
less is only a guide. It may increase or decrease depending
on the surrounding temperature and environment.
WARNING
Ɣ
Replace the blade to avoid injury from touching it .
NOTICE
Ɣ
Use the blade in a vertical position for easier and more efficient cutting.