7 DAB MODULE INPUT (230V version only)
The VISO THREE is compatible only with the NAD DAB Adaptor module
models DB 1 or DB 2.
•
Plug-in the other end of the Mini-Din connector from the NAD DAB
Adaptor module output port into this socket.
•
With DAB, you can receive CD-like quality programs without any
annoying interference and signal distortion.
NOTE
The external NAD DAB Adaptor module is not supplied with your VISO
THREE.
8 +12V TRIGGER OUT
The +12V TRIGGER OUT is used for controlling external equipment that
is equipped with a +12V trigger input.
•
Connect this +12V TRIGGER OUT to the other equipment’s
corresp12V DC input jack using a mono cable with 3.5mm
male plug.
•
This output will be +12V when the VISO THREE is ON and 0V when
the unit is either OFF or in standby mode.
9 MP DOCK
The VISO THREE is equipped with a data port in the rear panel where
an optional NAD IPD (NAD IPD Dock for iPod) 1, NAD IPD 2 and later
variants can be plugged in.
•
Connect the “MP DOCK (DATA PORT)” jack of the VISO THREE to the
corresponding “DATA PORT” socket of the optional NAD IPD model.
Refer also to the “LISTENING TO YOUR iPod PLAYER” segment of the
“OPERATION” section.
NOTE
The NAD IPD 2 Dock for iPod (NAD IPD 2) is supplied with your
VISO THREE.
10 RS-232
NAD is a certified partner of AMX and Crestron and fully supports
these external devices. Check out the NAD website for information
about AMX and Crestron compatibility with NAD. See your NAD audio
specialist for more information.
•
Connect this interface using RS-232 serial cable (not supplied)
to any Windows® compatible PC to allow remote control of the
VISO THREE via compatible external controllers.
11 AC MAINS INPUT
The VISO THREE comes supplied with a separate detachable mains
power cord. Before connecting the plug to the mains power source,
ensure that it is firmly connected to the VISO THREE’s AC Mains input
socket first.
•
Connect only to the prescribed AC outlet, i.e., 120V 60 Hz (for 120V
version models of VISO THREE only) or 230V 50 Hz (for 230V version
models of VISO THREE only).
•
Always disconnect the mains power plug from the mains power
source first, before disconnecting the cable from the VISO THREE’s
AC Mains input socket.
12 SWITCHED AC OUTLET
This convenience outlet can supply switched power to another
component or accessory.
·
The total draw of all devices connected to this outlet must not
exceed 100 watts.
·
It is powered ON and OFF by the front panel Standby button or by
the VR 3’s ON and OFF keys.
IDENTIFICATION OF CONTROLS
REAR PANEL
9
EN
G
LI
SH
PO
R
TU
G
U
ÊS
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
