ENGLISH
Music Library
1 Reindex Library:
Scan for new files added to the Music Library
Other
1 Language:
Select available language. The screen display will be
shown in the language selected.
2 Reboot:
Cycle power by powering off and powering back the unit.
3 Factory Reset:
Restore to factory default settings
4 BluOS Upgrade:
Select “BluOS Upgrade” to initiate BluOS upgrade
mode. When “BluOS Upgrade” prompt appears, select “Yes” to
start BluOS upgrade process. Follow the display screen prompt to
complete the upgrade procedure.
NOTE
Not all languages selected may be available. They will eventually
become available via future software upgrade.
System Info
Display information about the following parameters
•
Show current or detected information about
BluOS firmware
version
,
IP Address
,
MAC Address Ethernet
and
MAC Address
Wi-Fi
.
• Temperature Left/Temperature Right:
If the internal temperature
of either left or right amplifier channel reaches 91 degrees
centigrade, M10 V2 will turn off automatically and a protect
message will be shown in the display. Once the temperature falls
below 80 degrees centigrade, M10 V2 will turn on again and the
protect message display will be cleared.
• Bridge Mode:
“On” or “Off” is shown depending upon the setting
(ON/OFF) of the Bridge Mode switch at the rear panel.
• AMP Protect/DC Error:
If an internal fault is detected, “Yes” is
shown in the display along with a message prompt instructing the
user to hard cycle the power of the M10 V2 - this is required to clear
the error. “No” indicates the unit is operating as intended.
IDENTIFICATION OF CONTROLS
TOP AND FRONT VIEW
11
1
1
2
3
4
