Magnum IV Control Manual for Gyro Tech Swing Door Systems
Page 23
www.NabcoEntrances.com
1/4/06
7.
Plug the power harness into the Magnum IV board. Connect the green wire (ground) to the header chassis,
black 120 VAC wire to black through thermal protector, and white wire to white wire as shown on the
next
page.
8.
Connect the four-pin plug from the limit switches to the plug at the end of the main harness. Figure 18)
9.
Connect the Rocker Switch to the terminal block of the main harness. (Figure 18)
10.
Connect the motor harness from J5 (marked MOTOR) on the Magnum IV board to the associated red and
black terminals on the motor. (Figure 18)
11.
Connect the six-pin connector from the main harness to J1 on the Magnum IV board.
12.
Connect the two-pin connector from the main harness to J2 (marked AUX PWR) on the Magnum IV
board.
13.
Connect the activation/detection devices to the terminal block of the main harness. (Figure 18).
14.
Cap off all unused wires.
