4 of 31
GT1175 Slide Door Opus Control Wiring and Programming Manual
www.NabcoEntrances.com
P/N C-00391
Rev 8-11-21
CHAPTER 2: SCOPE
SECTION 2.1: To the Installer
The purpose of this manual is to familiarize the installer with the proper installation and operation of this system. It is essential that
this equipment be properly installed and operational before the door is used by the public. It is the installer’s responsibility to inspect
the operation of the entrance system to be sure it complies with any applicable standards. In the United States, ANSI Standard 156.10
(Used to cover Full Energy doors) and ANSI Standard 156.19 (Used to cover Low Energy doors) apply. Other local standards or codes
may apply. Use them in addition to the ANSI standards.
If after troubleshooting a problem, a satisfactory solution cannot be achieved, please call Nabco Entrances at 1-877-622-2694
between 8 am – 4:30 pm Central time for additional assistance. This manual offers step by step instructions. Do Not take shortcuts.
SECTION 2.2: Objective
The Opus Control is designed to be installed within new Swing, Sliding, and Folding Door Units, plus:
X
Existing swing, sliding, and folding doors using Analog, Magnum, or U01-U19 controls (works with encoders or microswitches).
X
Existing sliding doors using U01-U19 controls. Contact Customer Service at 1-888-679-3319 to purchase Retrofit kits.
SECTION 2.3: Request a User Name/Password to gain access into the “myNABCO” portal
To gain access into the “myNABCO” portal, the User must first have an assigned User Name and Password. To request a User Name
and Password, the following must be done:
1. Open the NABCO Website: www.nabcoentrances.com
2. Enter the “myNABCO” portal → Request Access → Fill out the Request Access Form → Click onto Register
a. A User Name and Password will be emailed back to the requestor.
SECTION 2.4: QR Code Links
Android Phone Instruction to Scan QR Code
I-Phone Instruction to Scan QR Code
Downloading a QR Scanner by an Android Phone may vary.
1.
Google to download QR Scanner. Install.
2.
Place phone in front of QR Code. Scan.
1.
Click on Camera icon.
2.
Place phone in front of QR Code. Scan.
Associated Videos
QR Code
Associated Videos
QR Code
Opus - Navigating Top Level Screens
Opus - Wiring and Configuring for Electric Locks
Opus - Using the Rotary Dial
Opus - Connecting Mode Switches
CHAPTER 3: GETTING STARTED
SECTION 3.1: Features
Specification
Description
Power Close
Built-in
Back Check Angle Adjustment
►
5 to 35 degrees from Full Open position
►
Used with Encoder Motor only.
Latch Check Angle Adjustment
►
10 to 40 degrees from Full Closed position
►
Used with Encoder Motor only.
Built In Sequencer
Can activate Electric Locks
►
Electric Strikes
►
Electric Latch Retracted Panic Devices
