Nabco GYRO TECH GT-1175, Руководство по установке

Страница: 12 / 33

ElectricalInstallationManualU-30“D”Control www.NabcoEntrances.com
Part #C-00121 Rev. 8-25-16
4-10 IdentifyOperatingWires
CHAPTER 4: IDENTIFY OPERATING WIRES
Section 4a: 16 Pin Controller Terminal Block Assignments
Note: All wires are identified by color. All references to signals are made in connection with Common (Red).
Note: Use a flat-blade screwdriver to remove the Terminal Connector from the U30 Microprocessor Controller.
Ensure that all wires are matched to each appropriate Terminal. Each Terminal is numbered with
corresponding information on the Face Plate of the U30 Microprocessor Controller.
Note: Common Terminal indicates terminal can be Output or Input.
*
Color1/Color2 denotes a base wiring Color 1 with a stripe Color 2. For example: Black/Red
indicates a Black wire with a Red Stripe.
Terminal # Symbol Color Description
1 9DC12V Brown X Output terminal
• Sensor power source.
• Output is 12VDC with a maximum capacity of 350mA (.35 amp).
2 7 Red X Common terminal
• Provides common ground for the 12 VDC power and signal source.
3 61 Black
X
Input terminal
• Interior Activation signal.
• Opens the door in two-way and one-way modes only.
4 6B White X Input terminal
• Holding Beam signal.
• Opens or re-opens a Sliding door.
5 H Green X Input terminal
• Reduced Opening Switch signal.
• Reduces Slide door opening when switched to Red (7).
6 M0 Orange
X
Input terminal
• Mode Switch One (SW1).
• Used to acheive special functions. Please refer to “Switch Settings”
section within this chapter.
7 M1 Orange/
White*
X Input terminal
• Mode Switch Two (SW2).
• Used to acheive special functions. Please refer to “Switch Settings”
section within this chapter.
8 62 Black/
Red*
X Input terminal
• Exterior Activation signal.
• Opens the door in two-way mode only.
9 SQ Yellow
X
Input terminal
• Sequential Activation signal.
• Allows a sequence of signals to open and close Slide door.