NA MultiFlash JR, Руководство пользователя

Страница: 21 / 30

Gamma – Gamma correction curve selection. This sets direct relation between AC current to the LEDs and the
DMX value. The lower the value, the dimming curve and steps of intensity will be more noticeable at the bottom
of the DMX range. The higher the value, the smoother the bottom end of the curve will be where the human eye
detects more subtle changes.
Gamma 8 – 8-bit rate Gamma correction setup. Color dimming curve values can be set from 1.0 to 5.0 .
The default value is 3.0
Gamma 16 – 16-bit rate Gamma correction setup. Each color dimming curve values from 1.0 to 5.0 . The
default value is 1.0
Async Strobo – This special mode allows for fast programming and “one-hit” effects (see Strobe Modes
section of Manual). Default is OFF, turn ON to activate.
Upload – Upload software. Designed to cross-load software from one MultiFlash to others in the DMX data
chain. This should not be used when other fixture types are in the data chain. Use of this function will be
prompted by
Password . The password is 111 .
Line Freq – Line Frequency. Allows adjustment of MultiFlash input power frequency to match local source
power for minimum visual artifacts on camera. The setting depends on region of use and power source. There
are two options: 50Hz and 60Hz. Use the <UP> and <DOWN> buttons to change these values.
Reset – Set factory defaults. Two options: NO and YES . Use the <UP> and <DOWN> buttons to change
these values.
MultiFlash v8.9 and MultiFlash RDM v9.73 LED Color Output Calibration
In some cases, different versions and vintages of MultiFlash will exhibit slightly different levels of output of Red,
Green, Blue, and White. The method below describes the best way to match MultiFlash colors and output to
achieve the most consistent results possible.
Tools required:
DMX Source
LUX meter (for ideal results) or two sheets of white paper.
Setting the units up to be calibrated:
To enable calibration mode, first address the units to be calibrated to DMX “511”. A password prompt will
appear. Change the value on screen to “88” and hit the ENTER/ check mark button.
Enter the “CONFIG” menu and scroll down to “ENGINEER”.
In the Engineer menu select “XML” and choose “CALIBRATED”.
Go to the “CALIBRATE” menu option to access the calibration controls. This allows the operator to set
intensity for each color and adjust each color hue.
Intensity of each color adjusts the output of each color.
Red hue is changed by adding green color.
Green hue is changed by adding red or blue color.
Blue hue is changed by adding green color.
White hue (color temperature) is changed by adding blue or adding red and green.
21