NA MultiFlash JR, Руководство пользователя

Страница: 2 / 30

1. I
NTRODUCTION
P
RODUCT
O
VERVIEW
MultiFlash indoor LED fixtures are combination wash/strobe/blinders with over 1000 Watts of LED RGBW
brightness, 58,000 lumens, instantaneous color mixing, and 1200Hz refresh rate for smooth on-camera
dimming. Q+ Technology increases the brightness with practically no fan noise. Its “Theatre Mode” is effectively
silent, yet still 8% brighter than the original MultiFlash! One MultiFlash LED fixture does the job of many
conventional LED fixtures, saving setup time and labor. Just a few of the features include:
•
Simultaneous color wash, strobe, and blinder in ONE fixture! – saves labor, time, space, cost
•
Instantaneous RGBW color mixing with 1200Hz refresh rate – smooth on-camera dimming
•
Pixel-map feature – up to 12 (MultiFlash / MultiFlash Q+ / MultiFlash LR Q+/ MultiFlash Q+ Rayzr
100cm), 6 (MultiFlash Q+ Rayzr 50cm) or 4 (MultiFlash M3) discrete, individually-controlled LED
sections.
•
Optimized 36° beam width. 20°, 54°, and 70°options available.
U
NPACKING
I
NSTRUCTIONS
Upon receipt of the fixture, carefully unpack the carton and check the contents to ensure that all parts are
present and in good condition. Notify the shipper immediately and retain packing material for inspection if any
parts appear to be damaged from shipping or if the carton itself shows signs of mishandling. Save the carton
and all packing materials. In the event that a fixture must be returned to the factory, it is important that the fixture
be returned in the original factory box and packing.
POWER REQUIREMENTS
Before powering the unit, make sure the line voltage is within the range of accepted voltages. This fixture
accommodates 100-240VAC, 50/60Hz. All fixtures must be powered directly from a switched circuit and
cannot be operated with a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used solely as a 0-100% switch.
When powered up, MultiFlash performs a pre-programmed internal test. On initial power- up the factory
default DMX address appears on the display screen and MultiFlash is ready for operation. After initial power-
up, the last-saved DMX address will appear.
F
REQUENCY
S
ETTING
Depending on location, change the Default Frequency setting to match the mains power (e.g., US and
Canada should be set at 60Hz). Proper frequency setting will ensure minimum amount of visible artifacts
when using MultiFlash on camera.
2