NA MultiFlash JR, Руководство пользователя

Страница: 10 / 30

7) The work-state control panel display shows current DMX address (in this example 198 ). Additional info
is displayed under the DMX address: Selected control mode, channels used by this mode, and
occupied DMX addresses (DMX footprint).
In this example MODE: RGB pix:1 (10ch) DMX footprint: 198 - 207 (meaning: RGB control mode with 1 pixel
using 10 DMX channels uses DMX 198 to 207).
DMX Source – This device supports two DMX controlling modes through wired connection (DMX cable w/
XLR 5-pin connector).
To set required DMX source, you must:
1) Press and hold <MENU> button to open the Main Menu .
2) Use <UP> and <DOWN> buttons to find the DMX Source submenu and press <SELECT> button.
Control – MultiFlash fixtures are two fixtures in one (strobe and a wash/blinder fixture). In each of the control
modes, the fixture occupies varying numbers of DMX channels and has different control channels. To enter the
Control submenu, follow these steps:
1) Press and hold < MENU> button to open the Main Menu .
2) Use <UP> and <DOWN> buttons to find the Control submenu.
3) Press <SELECT> button to access the Control submenu.
4) Choose the correct control mode. Select from Basic or Advanced.
When the control submenu is opened, there are two settings to choose from:
Basic – This mode allows for simple control of the fixture as a Blinder/Wash fixture, or as a Strobe.
Advanced – This mode allows for independent control of Blinder/Wash functions, and the Strobe functions. This
mode also allows for independent color and intensity control of every segment of LEDs independently.
10