NA MultiFlash JR, Руководство пользователя

Страница: 5 / 30

S
ETTING UP A
DMX S
ERIAL
D
ATA
L
INK
1) Connect the male 5-pin XLR connector of the data cable to the female 5-pin XLR output of the DMX
console. Connect the other end of the data cable (female 5-pin XLR) to the male 5-pin XLR connector
located on the NA MultiFlash.
2) Connect from the fixture output as stated above to the input of the following fixture, and so forth.
3) Continue linking until the last fixture is connected in your DMX signal data chain.
F
IXTURE
M
OUNTING
Orientation
MultiFlash, MultiFlash Q+, MultiFlash Rayzr and MultiFlash Jr fixtures may be mounted in any position. Each
have a yoke with mounting hole for clamps or couplers. The MultiFlash LR Q+ comes with a bar yoke and will
also operate in any orientation. Always make sure there is adequate room for ventilation. Do not obstruct the
unit’s fan or vents.
Support Stand
Always use a professional stand rated to support weight greater than the fixture (see technical
specifications). Attach a TVMP spigot to the yoke of the MultiFlash or MultiFlash M3 and mount on
the stand.
Rigging – Always consult a certified rigging specialist before suspending any fixture overhead!
Use C- or O-type clamps for attaching to truss. It is important never to obstruct the fan or
vents pathway. Adjust the angle of the fixture by loosening both knobs and tilting the
fixture. After finding the desired position, retighten both knobs.
•
Always use safety cables!
•
When selecting installation location, consider routine maintenance.
•
Never mount fixture where it will be exposed to moisture, high humidity, extreme temperatures, or
restricted ventilation.
5