mylife My-F41L, Руководство пользователя

Страница: 81 / 94

My Life Hot Tubs 2019 Owner’s Manual
DOC: OM-MYLIFE-19
81
DRAINING YOUR SPA
KNOWING WHEN TO DRAIN
Dissolved solids from bather load and ongoing chemical treatment accumulate in your spa water. The early sign of a
high level of dissolved solids is unmanageable cloudy water.
When in doubt, remember that the best
chemical for your spa is fresh water!
HOW TO DRAIN YOUR SPA
1) Turn down the set point on your spa and allow adequate time for the water to cool down. Uncover and run
high speed pump to speed up cooling.
2) Turn power off to your spa.
3) Attach the appropriate size hose to the drain connection (see below).
4) Route the hose to an appropriate drain location.
5) When the drain is opened the spa will gravity drain, even unattended.
6) As draining proceeds, move water from contours of seats, into the footwell. Draining will stop due to drain
height.
7) Remove any remaining water with a shop vac, sponge and pail or simply dilute in your fresh fill.
8) Before refilling, clean spa surface as necessary.
9) Don't forget to close the drain before refilling.
If you want to speed up the draining process, simply use a submersible
sump pump available through most hardware stores.
Drain Connections
Hose Drain (Most Models)
Located behind the right, front corner, the flexible hose
drain easily connects to a standard garden hose. After
routing the garden hose to a suitable drain location, turn
off the spa, then turn the valve handle to open the valve
and start draining.
Accessing your spa’s drain connection:
The drain valve is located behind the front, right corner panel. This is usually the corner at the filter cover/serving
tray. Turn off power to the spa before draining.
To remove the corner:
1. Run your hand under the bottom of the corner, feeling for a center recess. This is the handle.
2. Pull outward to release corner from the bottom frame at the right & left spring clips.
3. Pull down on the corner to release the top of the corner from the upper frame at the right and left spring
clips. You may have inadvertently done this when you pulled the corner outward in step 2.