mylife My-F41L, Руководство пользователя

Страница: 22 / 94

22
DOC: OM-MYLIFE-19 My Life Hot Tubs
2019 Owner’s Manual
FILLING YOUR SPA
Okay, your new spa has been connected to the power and you have a basic understanding of how the equipment
works and what the jets can do for you. We know you are anxious to fill the spa and get it started, but please read
this section carefully before you fill your spa.
1) Make certain that the breaker or fuse(s) that supplies your spa equipment is off.
2) Wash the spa surface thoroughly with warm water and a soft cloth only to remove any construction or
transportation debris.
3) Check that the drain connection is closed.
4) Check that the unions on the spa pack and pump(s) are tight. They can loosen during transportation.
5) Open waterfall/water feature ON/OFF valve before filling. Refer to graphics on valve handle or simply turn
counter clockwise to open.
6) Begin filling the spa with a standard garden hose. Fill by inserting hose into skimmer body. Do not fill your
spa with soft water (consult dealer). If possible, your source fill water temperature should not be less than
70°F (21°C). Do Not operate the spa with low water levels. A level 4" over the bottom of the skimmer mouth
is recommended. Maximum initial water level should be 6” below the spa lip. Adjust as needed based on
number of bathers using the spa. Consider adding an overflow to your spa if you are regularly having enough
bathers in the spa to significantly raise the water level such that damage to equipment may occur.
7) Increase the fill pressure slowly to prevent surface damage by a jerking hose.
8) Visually check all lines for leaks and correct immediately. If you cannot stop the leak simply by tightening a
union or resetting an "O" ring or gasket, contact your dealer immediately.
9) Turn on the main power at your electrical panel.
10) The topside control panel will initialize and begin its’ start-up procedure. Then the system will start the
circulation pump(or low speed pump) and the heater.
11) Bleed entrapped air off the filter by opening the air bleed screw on the filter lid.
IMPORTANT:
Now, read about the keypad operation, user settings, system defaults, automatic functions
and display messages included in this manual (see User Guide in the Index).
Take a few minutes to try the various keys and features on your new spa.
Once you feel comfortable with the operation of your spa's controls, set the temperature to the desired level
(100°F/38°C is an excellent starting point). Close the air controls and cover the spa with your hard cover. Heat up
times will vary based on volume of water in the spa, but you can generally expect 6-8 hours to reach maximum
temperature. Spas running on 120VAC will have a longer initial heat-up time.
Always view the temperature display before entering the water. For your own personal safety, do not enter when the
temperature exceeds the maximum set point of 40°C (104°F).