
The MyGate Q71B Control Board Installation Manual : Printed 06/11/2012 14:25
12
Programming the remote control / key-fob
–
Please
have your key-fob(s) to hand
Every DOUBLE GATE automation kit comes equipped with 2 MyKey remote controls as standard.
These are three channel Rolling Code remote controls. Rolling Code means
the key fob has multiple combinations (like cut keys for a door lock) at its
disposal which can be changed at anytime digitally. Each channel sends an
individual code on a 433.92
MHz frequency that the control board’s internal
receiver intercepts. The key fob contains 16,000 code combinations.
When the remote control is transmitting, an LED will be seen lit on the
remote control. This is confirmation that the remote control is transmitting.
The remote control is powered by 12v A23 battery with an average life span of 3-5 years depending on
usage. When the capacity of this battery runs low, you may see the LED transmitting indicator on the key
fob lit faint and the control board may not respond to your command as the signal may be too weak. Before
we program your remote controls to the control board, select
one
button to act as the activation key for
your gate automation.
On the control board, towards the right hand side,
there are three buttons marked P1, P2 & P3
(illustrated right).
These are the control board’s
operational buttons. To program they remote
control to the control board, please follow next set
of
steps below:
Saving a new remote controls to the control board to open gates FULLY
a) Press
button
P1
on the control panel
once and hold for a few seconds then release.
The DL1 light will come on then will go off then come on again. You will hear the relay on
the control board click once. The light will stay on for 10 seconds, allowing 10 seconds to
program the remote control to the control board.
b) Press and hold the button on the remote control until the DL1 light goes off and the relay on
the control board “clicks”.
The control board can store up to 50 remote controls.
Saving a new remote controls to the control board to open gates as PEDESTRIAN (one leaf opens)
a) Press
button
P1
on the control panel
twice.
The DL1 light will flash each time then stay on.
The light will stay on for 10 seconds, allowing 10 seconds to program the remote control to
the control board.
b) Pick a separate button from the one you are using to open the gate fully - Press and hold
the button on the remote control until the DL1 light goes off and the relay on the control
board “clicks”.
Deleting existing remote controls / key-fobs from the control board
a) Press and hold the
P1 button
, the DL1 light will come on. Keep the button pressed until the
DL1 light goes off.