Mydax, Inc.
1M150W
Water Cooled Chiller
Designed for Lockheed Martin
3
There are potentially hazardous materials within the cabinet; see the MSDS, in Appendix C of this manual, for more
information on these materials.
This chiller contains fluids that may be slippery if spilled on the floor. The use of a drip pan may be required as a
means of avoiding a potentially hazardous spill. Clean up of any spills should follow the guide provided in the
MSDS.
Service of the refrigeration equipment shall be performed only by qualified and certified, if necessary, personnel.
Refrigerant gas is not to be vented to the atmosphere; it shall be handled according to regulations set forth by the
local environmental authorities. Refrigerants are fluorocarbon type materials and subject to environmental
regulations.
The compressor uses POE oil; this MSDS is available from Mydax upon request. The compressor is hermetically
sealed and no service should be required. In the event that cleanup is necessary, absorb oil with oil absorbent
material and dispose of as a hazardous waste. Follow approved cleanup procedures as listed in the MSDS.
Label 2
This "Hazardous Voltages" danger label has been placed on the clear guard inside the electrical panel box and on
each power junction box within the chiller cabinet. The label indicates that there are hazardous voltages on the
components within the protective enclosure. Before servicing, the equipment shall be disconnected from the source
supply and locked out with an appropriate device.
Electrical maintenance shall be performed only by qualified electricians and trained service personnel.
LITHIUM BATTERY
The M1001 controller contains a Lithium battery to retain setup parameters and calibration data. If this battery were
to fail (see Test Panel 7 in the Diagnostic Displays section of this manual), it shall be replaced with a compatible
type, and the replaced battery shall be recycled as required by local environmental regulations.
