original operating instructions mycusini
For questions please contact us at [email protected]
• Check the dosing tip for blockages.
• Insert the enclosed pin needle into the small opening of the stainless steel tip from
below and try to extrude again.
The printer stops printing for no obvious reason:
• Turn the printer off.
• take out the micro-card and insert it againwhile the printer is switched off
• Wait 20 seconds and switch on again.
• Check whether the cartridge is filled sufficiently and replace it if necessary.
• Turn the control knob until the Choco leaves the nozzle in a continuous flow
• Start the object print again
If the fault continues to occur even after following the instructions, create a new
object in mycusini club specified in chapter7
• Be sure to safely remove the micro SD card
•
Put the micro SD card in the designated slot. Then switch on the mycusini
If the fault continues to occur even after following the instructions, switch off the
device. Please contact our customer service at
immediately
for the purpose of an inspection or repair.
Many more tips and tricks as well as recipes, printing templates, and the most recent
information pertaining to 3D printing and the mycusini food printer can be found at:
www.mycusini.com
and
www.mycusini.club
9 Returning Old Devices
We will accept your old printer after its operating life has been exhausted. Please
contact our customer service department at:
10 Servicing and Maintenance
10.1 Safety instructions for servicing
The power cord should be checked for any signs of damage every now and then.
Never use the device if the cord is damaged. In case the cord shows any damage, it
has to be replaced by an approved customer service in order to avoid potential
hazards.
