MyBinding Standard APC45 Programmable, Инструкция по эксплуатации

Страница: 26 / 54

18
3-3 Cutting Operation by Programmed Value
Place the sheets.
- The maximum cutting height is 60 mm (2.36”).
- Arrange the sheets by aligning them with the
backgauge and side guide.
Do not pile the narrow sheets high.
Place the sheets on the other side so that
the clamp does not incline widely.
Perform the cutting operation of the
step 1.
- Press both cutting buttons.
- Release your hands from the cutting buttons
when the knife reaches the lower limit and
starts to lift.
- Press both cutting buttons at the
same time. If they are not pressed
within 0.5 seconds, the machine does
not operate.
- If your hand is released from one of
the cutting buttons while the knife is
lowering toward the lower limit, the
knife stops at that position.
- Release your hands from the cutting
buttons when the cutting operation is
completed. The secondary cutting
operation dose not start even if press-
ing them continuously after the cut-
ting process.
- When the step 1 is completed, the backgauge
pushes out the sheets for 50 mm (2”) and
moves to the position of the step 2.
Push-Out:
“Push-out” means to move the cut
sheets forward before the following pro-
cess by moving the backgauge forward.
The push-out length of this machine is 50
mm (2”). However, if the cutting length is
smaller than 90 mm (3.575”), the back-
gauge pushes out the sheets to the posi-
tion of 40 mm (1.575”).
The clamp and the knife move as follows
during the cutting operation.
- The clamp presses the sheets and the knife
lowers.
- The knife lifts and the clamp lifts.
Perform the cutting operation of the
step 2.
- Place and align the sheets to the backgauge
and side guide.
- Check that the following message appears on
the guide window, and press both cutting but-
tons.
- When the step 2 is completed, the backgauge
moves to the position of the step 3. (If the
backgauge moves backward, it pushes out
the sheets first and moves backward.)
Cutting Buttons
1 3 4 2
3:120.0 2:280.0
2 / 8 COURSE:3
Step 2
Step 3