14
3-2 Cutting Operation by Entering a Value
This section explains the cutting operation
when entering a value directly without
using program.
Press the
button.
- The LED on the upper left of this button is illu-
minated and shows that the “cutting operation
by entering a value” is selected.
Input the cutting length.
- Input using the numeric keypad. The input
value appears in the guide window.
- The value can be input in the range of 40 mm
to 450 mm (1.575” to 17.715”).
For inch version, only “0” and “5” can be
input to the third decimal place.
If the value out of range is input, “OUT OF
RANGE“ appears on the guide window. In
this case, press the
key and input the
correct value.
- (For mm version) The value can be input up to
the first decimal place.
- (For inch version) The value can be input up
to the third decimal place.
- If the value after the decimal point is “0”, the
decimal point and “0” is not necessary to be
input.
- The calculation keys can be used.
Example: If cutting the sheet whose length is
594 mm into half, press the
keys. The
backgauge moves to the position of 297 mm
Press the
key.
- The value is entered and the backgauge
moves to the position.
- When the backgauge moves to the input posi-
tion, the “beep” sounds and the value is indi-
cated in the box of the current position of the
backgauge.
WARNING
This machine must be operated by just one
person at a time.
CAUTION
Do not cut anything besides paper. This
may damage the machine.
Ent
9
4
5
2
Ent
LED
7
8
9
C
4
5
6
1
2
3
-
Ent
0
=
+
Guide Window
Clear
Enter (Input)
Ent
Содержание Standard APC45 Programmable
Страница 2: ......
Страница 8: ...VI This page is intentionally left blank...
Страница 12: ...4 This page is intentionally left blank...
Страница 50: ...42 This page is intentionally left blank...