15
Cu
ttin
g Ope
ra
tio
n by Enter
ing a V
alue
O
per
ation
Pr
oced
ur
es
3-2 Cutting Operation by Entering a Value
Set the automatic push-out mode.
- When the automatic push-out mode is
selected, the backgauge moves forward after
every cutting to push the sheets forward.
- Press the
button. The icon of the "Auto-
matic Push-Out Mode" appears on the guide
window.
- When pressing the
button again, the
automatic push-out mode is canceled.
- The push-out length is 50 mm (1.97", fixed).
However, the push-out length may be less
than 50 mm (1.97") according to the cutting
length (less than 90 mm [3.54”]).
Place the sheets.
- The maximum cutting height is 60 mm (2.36”).
- Arrange the sheets by aligning them with the
backgauge and side guide.
Do not pile the narrow sheets high.
Place the sheets on the other side so that
the clamp does not incline widely.
Press both cutting buttons at the
same time and keep pressing them.
- The cutting operation starts.
- Release your hands from the cutting buttons
when the knife reaches the lower limit and
starts to lift.
- Press both cutting buttons at the
same time. If they are not pressed
within 0.5 seconds, the machine does
not operate.
- If your hand is released from one of
the cutting buttons while the knife is
lowering toward the lower limit, the
knife stops at that position.
- Release your hands from the cutting
buttons when the cutting operation is
completed. The secondary cutting
operation dose not start even if press-
ing them continuously after the cut-
ting process.
The clamp and the knife move as follows
during the cutting operation.
- The clamp presses the sheets and the knife
lowers.
- The knife lifts and the clamp lifts.
Automatic Push-Out Mode Icon
Cutting Buttons
1
3
4
2
Содержание Standard APC45 Programmable
Страница 2: ......
Страница 8: ...VI This page is intentionally left blank...
Страница 12: ...4 This page is intentionally left blank...
Страница 50: ...42 This page is intentionally left blank...