Innovator Plus System Operations Manual
Page | 23
Connect Electrical
The Innovator Plus System comes standard with a 10-foot power cord for use with 110 VAC or
220 VAC. If the EHC-X option is installed, the unit must be power at 220 VAC. Refer to the
reference label on the panel for electrical connections.
Due to the variety of electrical codes, MVP does not supply connections to any of the heaters
available. The electrical connection must be made by a qualified electrician per the codes of the
local jurisdiction.
Perform Pre-Start Checks
15. Gather all tools and materials needed for the job.
16. Check all catalyst and resin fittings to be sure they are tight.
17. Fill the pump packing nut
1
3
full with TSL oil or
equivalent.
18. Fill the catalyst jug at least ½ full of appropriate catalyst.
19. Check the connection of the pick-up wand to the pump inlet
to make sure it is tight.
20. Place the resin pick-up wand in the resin supply container.
21. Make sure the flush tank is ¾ full of solvent.
22. Place an appropriate waste container under the injection head.
23. Connect the 6 mm air line to the air supply.
24. Slide the air valve to the
open
position.
25. Release the E-stop to allow machine operation.
26. Press the flush button to test the
flush system.
Load a Recipe
1. From the startup screen, select
.
2. Select the desired recipe
number.
3. Select Load Recipe.
4. When the recipe is ready for the
injection cycle, the status
indicator display changes to
RECIPE LOADED
.