MUTOH Spitfire 65, Руководство по обслуживанию

Страница: 171 / 319

Spitfire – Maintenance Manual
171
AP-74096, Rev. 1.0, 09/06/05
5.5.11. Head wash menu
In this menu, ink is drained and the head is cleaned at the completion of the manufacturing process and
before replacing the print head.
Execute a cleaning following the steps below.
Step 1 :
Initialize the waste ink history.
¾
Refer to ‘Parameter Initialization Menu’
Step 2 :
Discharge the waste fluid from the waste fluid bottle.
Step 3 :
Press the [ENTER] key in the operation panel to confirm the head cleaning menu.
Step 4 :
Remove all ink cartridges.
Step 5 :
Press the [ENTER] key in the operation panel to drain the ink.
Step 6 :
After the ink has been drained, install the head cleaning fixture.
Step 7 :
Press the [ENTER] key in the operation panel to supply the cleaning fluid.
Step 8 :
After the cleaning fluid has been supplied, remove the head cleaning fixture.
Step 9 :
Drain the cleaning fluid by pressing the [ENTER] key in the operation panel.
Step 10 :
Initialize the waste ink history.
Notes :
¾
When performing the ink cleaning, always initialize the waste ink history then start a
head cleaning. Otherwise, during cleaning, the waste ink tank becomes full and
cleaning is interrupted.
¾
After the head cleaning, always initialize the waste ink history. Otherwise, during
filling, the waste ink tank becomes full, and filling is interrupted.
¾
Before ink filling, discharge the cleaning fluid, and wait for at least 30 minutes.
Otherwise, the printing may be unstable.