MUTOH DT-Series, Руководство по эксплуатации

Страница: 40 / 96

Mutoh’s DT-Series Printers – Operation Instructions
40
AP-75171, Rev. 1.1, 25/06/04
To connect the power cable, follow the steps below.
Step 1 : Plug the power cable to the AC inlet on the back of the printer.
1. AC inlet 2. Power cable
Step 2 : Plug the cable correctly to the outlet.
Important :
•
Do not attempt to plug in electrical plugs with wet hands. Doing so may
result in electrical shock.
•
Be sure to use the specified voltage (AC 100V-120V/220V-240V). Otherwise,
electrical shock or fire may occur.
•
Use electricity directly from a power outlet (AC 100V-120V/220V-240V). Do not
put many loads on one electrical output. Otherwise, heat may be generated
and cause fire.
•
Be sure to use an outlet with an earth terminal, and use the terminal
correctly. Otherwise, electrical shock or fire may occur.
•
Do not connect earth cables in the following areas :
o
Gas pipes. Doing so may cause fire or an explosion.
o
Earth terminals for telephone lines or lightening rods. Doing so may
cause a large flow of voltage if lightening occurs.
o
Water pipes or faucets. If there is a plastic part in the pipe, the earth
will not work correctly.
Caution :
•
Follow the instructions below when handling the power plug. Otherwise, fire may
occur.
o
Wipe away dust and any other residue before inserting the plug.
o
Ensure that the plug is firmly inserted as far as it will go.
•
Ensure that the plug has been disconnected from the power socket when it is not
used for a long time.
•
Earth wires must be connected to wires or terminals that fulfill the conditions :
o
Earth terminals of power socket
o
Earth wires with copper morsel that is at least 650 mm under ground