02/2014
_____________________________________________________________________________________________________________________
23
6.1.
Menu bar and commands
6.1.1.
File
Load configuration
The MTP200 parameter set saved in a file with extension
*.MTP
on the hard drive is loaded into the Windows
configuration program. Thus a parameter set already created and saved can be copied fast and reliably into
other devices, if the same configuration is needed for these.
6.1.2.
File
Save configuration
The MTP200 parameters of the configuration program are saved on the hard drive in a file with the extension
*.MTP
and archived. For later duplication into another MTP200, the file must only be loaded in the set-up
program and transferred in the MTP200 with the command
MTP program
.
6.1.3.
File
Print configuration
All MTP200 parameters of the configuration program and the first 60 characters of the comments are printed
out as a dated protocol and the device characteristic data on a DIN-A4 page. The printer available under
Windows is used. The character font and print format are fixed and cannot be changed by the user.
6.1.4.
File
Print comment
The extensive comments saved in the device as dated protocol with a maximum 2000 ASCII characters and
the device characteristic data are printed out on a DIN-A4 page. The printer available under Windows is used.
The character font and print format are fixed and cannot be changed by the user.
6.1.5.
File
Quit program
The message
Program quitting
appears with a request for confirmation by
OK
or
Cancel.
6.1.6.
Access rights
Enter password
After the corresponding password is entered, entry is enabled to the otherwise locked functions of the
configuration program.
The configuration program is divided into 3 access areas:
The
open program area
contains no settings and so is always accessible.
Password level 1
contains all parameter settings.
Free input to this level is secured only after password assignment
Password level 2
contains calibration excluding configuration. This input is secured by a password assigned
by the manufacturer (
5180
). Of course this password can be replaced with a new one by the user. Furthermore
password 2 gives access to all parameters and functions of the device.
