Must PH50-10000T, Руководство пользователя

Страница: 16 / 32

-13-
To mount the inverter on the wall, we should mount expansion bolt to the wall firmly first.
In order to avoid electrical shock or other injury, inspect existing
electronic or plumbing installations before drilling holes.
danger
4.5 Installation the Inverter
4.5.1 Mounting Expansion Bolt
Fig4.6
Please make sure the inverter is installed at the right place.The inverter can’t install close
to trunk.
1. Please make sure the thickness of the wall for inverter installation is more
than 600mm;
2. Please place the bitmap horizontally on the wall and confirm the level by
level;
3. Please mark the holes in the 4 mounting holes of the hoe pattern;
4. Drill a hole with a depth of 55mm at the mark with a drill of φ8mm
5. Please expand the bolt with a hammer into the hole in the wall and install the
nut (including elastic flat pad), do not tighten the nut;
6. Please hang the inverter on the expansion bolt and tighten the nut with a
wrench.
7000-15000T Hole pape
470.25mm
2
0
5
.0
0
m
m
Steps:
Drill four holes for expansion bolt use the fix hole paper as template
Fix the mounting expansion bolt on the wall as the figures shown below. combine four
expansion bolt with four M6 Nuts. Refer to Fig4.7