6. REFRIGERANT PIPE INSTALLATION
Ventilate the air if there was any refrigerant leakage during
installation.Leaked refrigerant will generate poisonous gas if
meeting fire.
Make sure there is no refrigerant leakage after installation.
Leaked refrigerant will generate poisonous gas if meeting fire.
6.1 Allowed Length and Drop of Piping
Requirements are different when installing the Outdoor
Unit, Please refer to Outdoor Unit Installation Manual for
detailed information.
6.2 Material and Size of the Piping
Size(mm)
Pipe Material
Copper Pipe for Air Conditioner
Model(kW)
Φ12.7
Φ6.4
≤4.5
(Gas side)
(Liquid side)
Φ15.9
Φ9.5
≥5.6
6.3 Refrigerant Volume to Be Added
Refrigerant Volume to be added is calculated according to
Outdoor Unit Installation Manual.
Be save to add refrigerant measuring by a scale.
If refrigerant volume added is inadequate (too much or
insufficient),the compressor malfunction will be caused.Be
sure to calculate the refrigerant volume carefully.
The service man should note down the piping length and
refrigerant volume added on the nameplate, which is on the
Electric Control Box Cover of outdoor unit for to diagnose the
compressor when compressor malfunction occurs.
6.4 Connection of the Refrigerant Pipe
Connection of the refrigerant pipe should
be done by professionals.
Double-span should be used when
connecting pipesof Indoor Unit.
Table 6-1
Fig.5-11
Fig.5-12
Connective
cable
Drain hose
Connective
pipe
Pipe room
Pond box
Wrapping belt
Indoor unit
.
..
..
.
..
.
..
.
.
.
.
.
.
.
.. .
..
.
.
.
.
.
.
.
. .
.
3 Piping and bandaging
Wind the connective cable, drain hose and wiring with tape
securely, evenly as shown below.
5.4 Indoor Unit Installation
Pass the piping through the hole in the wall.
Put the claw at the back of the indoor unit on the hook of
the installation board, move the Indoor Unit from side to
side to see that it is securely hooked.
Piping can easily be made by lifting the indoor unit with
a cushioning material between the indoor unit and the
wall. Get it out after finish piping.
Push the lower part of the Indoor Unit up to the wall,Then
move the Indoor Unit from side to side, up and down to
check if it is hooked securely.
Because the condensed water from rear of the indoor unit is
gathered in Pond Box and is piped out of room. Do not put
anything else in the box.
hooker
Cushioning
material
̚
̚
;
<
3
4
E Y X
P Q E
;
<
3
4
L
N
CAUTION
CAUTION
The temperature of refrigerant circuit will be high, please
keep the interconnection cable away from the copper tube.
CAUTION
SW1
ON
SW1
ON
SW1
ON
S W 2
ON
S W 2
ON
SW6
O
N
ON
ON
SW5
ON
Installation manual
Wall mounted split
6
