990
53
315
561
1194
55
343
335
307
̚
̚
;
<
3
4
E Y X
P Q E
;
<
3
4
L
N
4. INSPECTING AND HANDLING THE UNIT
At delivery, the package should be checked and any damage should
be reported immediately to the carrier claims agent.
When handling the unit, take into account the following:
5. INDOOR UNIT INSTALLATION
5.1 Installation place
Fragile, handle the unit with care.
Keep the unit upright in order to avoid compressor
damage.
Choose on before hand the path along which the unit is to be
brought in.
Move this unit as originally package as possible.
When lifting the unit , always use protectors to prevent belt
damage and pay attention to the position of the unit’s centre
of gravity.
1
2
3
4
Installation Board and Its Direction (unit: mm)
1 Fix the installation board.
Install the installation board horizontally on structural parts in
the wall with the spaces provided around the plate.
In case of brick, concrete or similar type walls,make 5mmdia,
holes in the wall. Insert clip anchors for appropriate mounting
screws.
Fix the installation board on the wall.
5.2 Drilling A Hole and Mounting Installation
Board
2.2\2.8 kW
3.6\4.5\5.6 kW
Fig.5-3
Fig.5-1
Right installation
Fig.5-4
mounting board of indoor unit
horizontal line
Avoid installing it in a narrow sapce which has a high
requirement to noise.
The ceiling is horizontal, and its structure can endure the
weight of the indoor unit.
The outlet and the inlet are not impeded, and the
influence of external air is the least.
The air flow can reach throughout the room.
The connecting pipe and drainpipe could be extracted out
easily.
There is no direct radiation from heaters.
Don't install it in a place whose air contains much salt. If
this can't be avoided, choose a anticorrosive model.
The indoor unit should be installed in a location that meets
the following reauirements:
CAUTION
Installing the equipment in any of the following places may lead to
faults of the equipment (if that is inevitable, consult the supplier):
A. The site contains mineral oils such as cutting lubricant.
B. Seaside where the air contains much salt.
C. Hotpring area where corrosive gases exist, e.g., sulfide gas.
D. Factories where the supply voltage fluctuates seriously.
E. Inside a car or cabin.
F. Place like kitchen where oil permeates.
G. Place where strong electromagnetic waves exist.
H. Place where flammable gases or materials exist.
I. Place where acid or alkali gases evaporate.
J. Other special environments.
the shape of indoor unit
7.1\8.0\9.0 kW
the shape of indoor unit
the shape of indoor unit
Fig.5-2
SW1
ON
SW1
ON
SW1
ON
S W 2
ON
S W 2
ON
SW6
O
N
ON
ON
SW5
ON
440
835
280
45
375
186
Installation manual
Wall mounted split
4
