5. Select the required output protocol from the menu.
6. Open the housing again and place the jumper back in it’s opened position.
7. Close the housing.
Jumper Opened Jumper Closed
Once in the programming mode (step 5) you have the following menu at your disposal:
1 + A
: WIEGAND 26 bit protocol selected
2 + A
: WIEGAND 30 bit protocol selected
3 + A
: DATA/CLOCK protocol selected
4 + A
: CODIX bus protocol selected
Note that this only needs to be done once during initialization. Once this operation is done the user will
obtain the programming menus as described below.
Note: If programming for WIEGAND or DATACLOCK format is continued immediately after the
selection of the protocol you only need to open and close consecutively the housing of the keypad. You
can continue immediately with step 5 in the programming menus of the selected protocol.
3.2 WIEGAND 26 bit format
3.2.1 Programming Jumper
The programming jumper allows the user to modify several code features sent by the MONO-S to
comply with the specific needs of the host and to increase the overall security level of the system.
A fixed header (from 0 to 255) can be added to the 26-bit WIEGAND output with this jumper. This
header may be used as a site code. Security is increased when the host control unit can be programmed
in such a way that no readers can be accepted unless they have this fixed header
On the other hand, it is possible to reduce the number of codes that can be sent to the host in case
there is limited available memory space. This prevents any coincidental interference between the codes
sent out by the MONO-S and the codes already in the system's memory. For example the host control
unit can see the keypad code 5 as a magstripe card with code 5.
3.2.2 Entering the programming mode
1. Open the keypad housing.
2. Place the jumper in it’s closed position.
3. Close the housing
4. A long beep will be heard and the Yellow LED will light up. Wait until the beep stops. This should
take about 4 seconds.
5. Select the correct settings from the menu below.
6. Open the keypad housing and place the jumper back in it’s opened position.
7. Close the housing.
Jumper Opened Jumper Closed
6
Содержание MONO-S
Страница 1: ......
