Multitone RPR 563GS, Техническое руководство

Страница: 49 / 87

RPR 563GS/KGS
TM1187A Issue C Page 5 - 5
Figure 1: Belt Clip Removal
DISASSEMBLY
Belt Clip Assembly
7. Referring to Figure 1, apply pressure to the centre of the clip (marked `A') so that its
mounting spring sits proud of its recess, then use a 4mm wide blade (at position `B') to
prise the spring away from the case.
8. To refit the clip, locate the lower end of the clip spring into the corresponding cut-out in
the case, then apply pressure to the centre of the clip, forcing the other end of the
spring into its corresponding recess.
Removing the Antenna
9. One of two antennas may be fitted. If the antenna is of the telescopic type, fully retract
it prior to removal. To remove the antenna, unscrew it (anti-clockwise) from the case
using a 9mm A/F spanner. Note that early telescopic versions have a knurled base.
Decasing the Transceiver
10. To decase the transceiver, refer to Figure 2 and carry out the following procedure:
a) Remove the antenna as detailed in paragraph 9. Note that failure to remove the
antenna prior to disassembly may result in damage to the PCB assembly or
antenna.
b) Remove the battery pack by pressing the battery release button inwards and sliding
the battery pack away from the transceiver.