Multitech MultiModem MT2834ZPW, Руководство пользователя

Страница: 75 / 94

Appendix A - Regulatory Information
75
Compliance with BABT Requirements
Approved for connection to telecommunications system specified in the
instructions for use subject to the conditions set out in them.
Warning: Interconnection directly, or by way of other apparatus, of
ports marked ‘SAFETY WARNING see instructions for use’ with ports
marked or not so marked may produce hazardous conditions on the
network. Advice should be obtained from a competent engineer before
such a connection is made.
It is a condition of approval that the power required by the host and the
total of all adapter cards installed within the host environment, together
with any auxiliary apparatus, does not exceed the power specification
as stated in the Technical Reference Material of the host apparatus.
The power requirements for the MT2834ZPW are:
Modem operating voltages: +12 VDC, -12 VDC, +5 VDC
Modem power consumption: 1.2 Watts
In order to maintain the independent approval of this card, it is essential
that when other option cards are introduced which use or generate a
hazardous voltage, the minimum creepages and clearances specified in
the following table are maintained. A hazardous voltage is one which
exceeds 42.4 VAC peak or 50 VDC. If you have any doubt, seek advice
from a competent engineer before installing other adapters into the host
equipment.
The equipment must be installed such that with the exception of
connection to the host, clearance and creepage distances shown in the
following table are maintained between the card and any other
assemblies which use or generate a voltage shown in that table. The
larger the distance shown in brackets applies where the local
environment within the host is subject to conductive pollution or dry
nonconductive pollution which could become conductive due to
condensation. Failure to maintain these minimum distances would
invalidate approval.