Multitech MultiConnect MT100EOCG, Руководство разработчика

Страница: 21 / 49

DEVELOPER’S KIT AND DEVELOPER’S BOARD OVERVIEW
MultiConnect® OCG-E MT100EOCG-EV3 Developer Guide 21
MT100EOCG-DK LEDs Description
LED 1 General Purpose LED1 output.
LED 2 General Purpose LED2 output (status).
LED 3 General Purpose LED3 output (link status).
LED 4 General Purpose LED4 output.
LED 5 General Purpose LED5 output.
LED 6 General Purpose LED6 output.
LED 7 Ethernet link.
LED 8 Ethernet speed.
LED 9 DTR.
LED 10 DCD.
LED 11 RXD.
LED 12 TXD.
LED 13 POWER.
Logging into the MultiConnect OCG-E Gateway
To log into the MultiConnect OCG-E gateway and open the modem port, use SSH or the debug serial port.
1. To use SSH to log into the gateway:
The default IP address is 192.168.2.1.
The default username and password are: root and root.
2. To use the debug serial port:
The debug port serial settings are 115200 baud, 8N1, with no flow control.
The default username and password are: root and root.
Safety Notices and Warnings
This section describes safety statements that OEMs can use in their product documentation.
Radio Frequency (RF) Safety
Due to the possibility of radio frequency (RF) interference, it is important that you follow any special regulations
regarding the use of radio equipment. Follow the safety advice given below.
Operating your device close to other electronic equipment may cause interference if the equipment is
inadequately protected. Observe any warning signs and manufacturers’ recommendations.
Different industries and businesses restrict the use of cellular devices. Respect restrictions on the use of
radio equipment in fuel depots, chemical plants, or where blasting operations are in process. Follow
restrictions for any environment where you operate the device.
Do not place the antenna outdoors.