Multi-Tech CallFinder Quick Start Server Installation
9
3. Connect CallFinder to DID Lines
Plug one end of the phone cable into the CallFinder’s Channel 1 DID
jack and the other end into an analog DID trunk line jack. The DID
Line cable is included with your CallFinder.
Caution
:
The DID Line cable has an RJ11 connector on
one end (this is the larger of the two connectors; it
goes to the telephone wall receptacle). The DID
Line cable has an RJ12 connector on the other
end (this is the smaller connector; it goes to the
DID Port on the CallFinder unit).
Never plug the DID connector into a standard
POTS Line. This may damage the CallFinder or
the central office equipment. Use only an analog
DID Line.
Repeat for the CallFinder’s Channel 2 DID port.
4. Connect CallFinder to Ethernet Network.
Plug one end of your RJ45 ethernet cable into the CallFinder’s
ethernet jack and the other end into your network ethernet hub. This
ethernet cable is not included with your CallFinder unit.
Caution
:
Before connecting to the Ethernet Network, make
sure that the network to which you are connecting
the CallFinder is not a 192.168.2.x subnet.
If it is a 192.168.2.x subnet, it will clash with the
CallFinder because the CallFinder’s default IP
address is 192.168.2.1. To remedy such a
situation, connect from the Admin PC to the
CallFinder using an RJ45 crossover cable until the
CallFinder’s IP address has been configured.
Thereafter, connect the CallFinder into the
network with an ordinary RJ45 cable.
