MULTIQUIP Whiteman WBH-16EAWD, Руководство по эксплуатации и запасным частям

Страница: 17 / 70

MQ-WHITEMAN WBH-16EAWD POWER BUGGY — PARTS & OPERATION MANUAL — REV. #5 (01/05/07) — PAGE 17
WBH-16EAWD POWER BUGGY — COMPONENTS
1. Tub or Bucket – Used for the transportation of material.
Tub holds approximately 16 cubic feet ( .59 cubic yards) of
water.
2. Handle Bar (Steering) - When driving the AWD Power
Buggy, use both hands and hold onto both handle bar grips.
This handle bar is used to steer the buggy.
3. Kill Switch – In the event of an emergency press this
button to stop the engine.
4. Fuel Tank/Cap – Remove this cap to add fuel. Tank holds
approximately 5.5 U.S. gallons. DO NOT over fill.
5. Speed Control – Sets the power buggy's travel speed.
When fully depressed, the AWD Power Buggy will be at
FULL speed. When released the AWD Power Buggy will
STOP .
6. Parking Brake Lever – When this lever is activated (pulled
down) the parking brake will be set. To release the braking
pull the lever upwards.
7. Travel Lever – When the travel lever is pushed forward
the buggy will travel in the forward direction. Placing the
travel lever in the backward position will cause the buggy
to travel in the reverse direction. Center position is neutral.
8. Brake Pedal – Press this pedal with the right foot to stop
the buggy.
9. Operator Platform - When the buggy is in use, the operator
shall ALWAYS stand on this platform while holding onto
the handle bar (steering).
10. Engine - The AWD Power Buggy uses either a electric or
recoil start Briggs & Stratton 18HP Vanguard engine.
Figure 4. AWD Power Buggy Components
11. Dump Pedal - Use this pedal to place the tub in the dump
position (vertical), press pedal a second time to return tub
to the travel position (horizontal)
12. Battery - Used for electric start of the AWD Power Buggy.
13. Forklift Pockets - When lifting of the buggy is required,
use these fork lift pockets to lift the AWD Power Buggy.
Remember to insert the forks of the fork lift a minimum of 24
inches into power buggy's fork lift pockets.
14. Dump Control Lever - Use this lever forward to place the
tub in the dump position (vertical), move the lever backward
to return the tub to travel position (horizontal)
15. Towing Hook - Use this hook to tow the buggy if it gets
stuck. This hook is NOT intended for the buggy to be towed
on public roads at high speeds.
16. Traction Assist Button- Engaging the traction assist
system while in AWD mode provides enhanced traction
control.
The traction assist switch is not intended for
extended use. Increased hydraulic
temperature may result from extended use
of the traction assist system and could
damage your AWD Power Buggy
CAUTION:
17. AWD/2WD Toggle Switch- Use when AWD is needed for
extended period of time. Toggle the switch to AWD to engage
the system.