MULTIQUIP Whiteman WBH-16EAWD, Руководство по эксплуатации и запасным частям

Страница: 27 / 70

MQ-WHITEMAN WBH-16EAWD POWER BUGGY — PARTS & OPERATION MANUAL — REV. #5 (01/05/07) — PAGE 27
WBH-16EAWD POWER BUGGY — MAINTENANCE
Engine
Refer to the Briggs and Stratton engine owner’s operating
manual for specific information.
Check engine oil after every 10 hours of operation and maintain
proper levels.
Drain oil after every 50 hours of operation and refill with grade of
oil recommended below:
Above 40
o
F. (13
o
C.) - S.A.E. 30
Below 40
o
F. (13
o
C.) - S.A.E. 20
Adding Hydraulic Oil
Check the hydraulic oil level in the hydraulic oil tank, by reading
the hydraulic oil sight glass mounted on the hydraulic oil tank. If
the hydraulic oil level is low fill to the proper level with MOBIL
300, GM DEXTRON B, FORD M2C-33F, FORD M2C41A hy-
draulic oil or equivalent.
1. To gain access to the hydraulic oil filler hole (Figure 24), the
dump tub (bucket) must be put in the dump position (vertical).
Start the engine as outlined in the starting procedure, then
place the tub in the dumping position.
2. Use the tub support rod to support the tub, then turn the
engine OFF . Remove the hydraulic oil filler cap, and add
hydraulic oil as required. Fill to the normal operating mark as
indicated on the hydraulic oil sight gauge.
Replace hydraulic oil after every 200 hours of operation. The
hydraulic oil filter should be changed each time the hydraulic oil
is changed.
Hydraulic Drive Motors
The hydraulic drive motors are extremely reliable and will not
need maintenance or repair under normal conditions. Should
any problems develop with the hydraulic drive motors, contact
Multiquip's service department.
Brake Adjustment
Brake adjustment can be made on the brake linkage rod located
on the right-side of the buggy. Place the parking brake lever in
the engaged position. The parking brake should be adjusted so
that the AWD Power Buggy will not move.
Adjustment is provided by a know at the end of the parking brake
lever, and the adjustment may be tightened by turning the knob
counter-clockwise.
Adjust sufficiently tight so that when the parking brake lever is
actuated, considerable pressure is required to place it in the
over center or
ON position. With the parking brake engaged, the
AWD Power Buggy should not move when the engine is started
and the travel lever pushed forward.
Chassis Lubrication
The AWD Power Buggy is equipped with zerk fit-
tings, lubricate these zerk fittings each day before
operating the AWD Power Buggy with high grade
chassis lubricant at all lubricating points listed
below:
■
Dump Cylinder Pivots - two zerk fittings
■
Tub Bearing Pivot Blocks (underside of tub)- four zerk fittings.
■
Steering Bearing Flange (Front side of handle bar) - 0ne zerk
fitting.
■
Remove rear wheel hubs and repack bearings after every
400 hours of operation.
Figure 24. Hydraulic Oil Tank/Cap
NOTE
In climates where temperatures
are below 35°F hard starting may
occur. In these cases the hydraulic
oil should be switched to a thinner
15 weight hydraulic fluid.