MULTIQUIP Whiteman WBH-16EAWD, Руководство по эксплуатации и запасным частям

Страница: 23 / 70

MQ-WHITEMAN WBH-16EAWD POWER BUGGY — PARTS & OPERATION MANUAL — REV. #5 (01/05/07) — PAGE 23
WBH-16EAWD POWER BUGGY — OPERATION
AWD Power Buggy Operation
Checking The Work Area
Inspect the surface over which you will travel. Look for holes,
drop-offs and obstacles. Look for rough spots. Look for weak
spots on docks, ramps or floor. Look for oil spills, wet spots and
slippery surfaces. Look for soft soil, deep mud and standing
water. Watch for anything that might make you lose control or
cause the Buggy to tip over.
Clear away trash and debris. Pick up anything that might punc-
ture the tires. Make sure aisles, ramps, doorways and passages
are clear. Plan your work. Make sure you know where you will
make your pickups, dumps and turns. Before you take a load,
know where you will place it.
Checking Overhead Obstacles
Check the clearances of doorways, canopies and overheads.
Know exactly how much clearance you have under power and
telephone cables. Also check clearances when transporting the
AWD Power Buggy on a truck or trailer.
Hauling Capacities
Know the rated load capacities of your AWD Power Buggy and
never exceed them.
ALWAYS refer to buggy’s rated hauling
capacity before loading. Keep in mind that the AWD Power Buggy
will normally operate on uneven, unpaved and often very bumpy
or inclined surfaces. Operating conditions can reduce the amount
that should be carried.
ALWAYS exercise extreme caution when
hauling to avoid tipping of the AWD Power Buggy.
Loading
If possible, plan to load, unload and turn of flat level ground.
When you travel with a load, keep the speed reasonable for the
load and the terrain to be traveled. The AWD Power Buggy is
less stable when traveling with a load.
WARNING
Transporting
When transporting the Buggy on a truck or trailer, know the over-
all height to avoid contacting overhead obstructions such as
bridges, power lines, etc. Make sure all tie-downs and block are
in place and the bucket is completely lowered and securely
latched. If you Buggy is to be hauled by truck, check the truck
and ramp capacities.
Parking
Park your Buggy in a designated area or out-of traffic preferably
on level ground.
If parking on a slope or incline, position the AWD Power Buggy
at right angles to the slope, set the parking brake, and block the
wheels, if required.
■
Avoid sharp turns at high speed.
■
If you cannot see where you are going, get someone
to direct you
■
Watch out for hazardous working conditions. It is you
responsibility to evaluate working conditions, and adjust your
work operation accordingly to prevent accidents.
■
When travelling over soft ground or wet/icy surfaces, slow
down.
■
Travel only at speeds that permit stopping in a safe manner.
■
This is a one-person AWD Power Buggy. NEVER permit
additional riders to stand on the platform or ride inside the
tub.
WARNING: WARNING:
WARNING: WARNING: WARNING:
NEVER approach
power lines
with any part
of the buggy unless all local, state/provincial
and federal (OSHA) required safety
precautions have been taken. Use extreme
CAUTION! when approaching high voltage
power lines.