MULTIQUIP JH55C, Руководство по эксплуатации и запасным частям

Страница: 27 / 104

JH55C WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #2 (9/4/15) — PAGE 27
7. Before the trowel is placed into operation, run the
engine for several minutes. Check for fuel leaks, and
noises that would associate with a loose guard ring
and/or covers.
To Begin Troweling
1.
To begin troweling, place the throttle lever (Figure 32) in
the "
RUN
" position.
Figure 32. Throttle Lever (Run)
2.
Squeeze the pull the clutch lever
(Figure 33)
to begin
4-blade rotation. Verify that the blades are rotating
.
Figure 33. Clutch Levers (Blade Activation)
Concrete Finishing Techniques
The following steps are intended as a basic guide to
machine operation, and are not to be considered a complete
guide to concrete finishing. We suggest that all operators
(experienced and novice) read “
Slabs on Grade
” published by
the American Concrete Institute, Detroit, Michigan . Read
the “Training” section of this manual for more information.
THROTTLE
LEVER
RUN
Right Clutch
Lever
Left Clutch
Lever
OPERATION
Pitching the Blades (Standard Handle)
To pitch the blades upwards using the "
Standard
" handle,
(Figure 34) simply turn the star-wheel clockwise. Turning the
star wheel counter clockwise will cause the blades to lay flat.
Figure 34. Blade Pitch Star Wheel
Pitching the Blades (Quick Pitch™ Handle)
To pitch the blades upwards using the "
Quick Pitch™
"
handle, (Figure 35) simply pull the T-handle backwards while
squeezing the trigger. Pushing the T-handle forward will cause
the blades to lay flat.
Figure 35. Blade Pitch T-Handle
INCREASE
BLADE PITCH
(CW)
DECREASE
BLADE PITCH
(CCW)
BLADE PITCH
STAR WHEEL
NO PITCH
(BLADES FLAT)
BLADES PITCHED
UPWARDS FLAT
T-HANDLE
TRIGGER
(SQUEEZE)