Multi-Tech MultiFRAD FR2201, Быстрый старт

Страница: 16 / 28

MultiFRAD II Quick Start Guide
16. The default Ethernet IP Address has to be changed to your
unique LAN address. Enter an acceptable, unique IP
address in the Ethernet port IP Adress field.
17. Change the default Subnet Mask and Frame Type to the
values you have assigned to your LAN port.
18. The default WAN Address has to be changed to your
unique WAN address. Assign an acceptable unique WAN
Address to the WAN port.
19. Change the default Subnet Mask and Remote Address
for WAN to the values you have assigned to your WAN.
20. Click OK when you are satisfied with your selections.
21. The WAN Ports Default Setup dialog box is displayed.
The WAN Port is enabled in this dialog box. Frame Relay
is also enabled. If your WAN port is going to be used in
Point-to-point protocol, click Enable PPP. When PPP is
enabled, the Modem Command Setup field becomes
active and either Asynchronous or Direct Connect needs
to be checked (enabled).
The WAN port can be further configured (after the
software installation is completed) by clicking the
MultiFRAD Configuration icon and then clicking the WAN
button.
22. Click OK on the WAN Ports Default Setup dialog box.
23. The Data Port Configuration dialog box enables you to
individually configure the two data channels (Port 1 and
Port 2).
If you are connecting to a synchronous device, ensure that
16